view 3rdparty/drivers/ide/idedesc.asm @ 3215:195c09cade21

Updated MMC Driver makefile so it will have place holders for dsk, dskclean, and dskcopy so that make does not error out when chaining into the driver tree to build disk images where applicable.
author David Ladd <drencor-xeen@users.sourceforge.net>
date Wed, 20 Dec 2017 16:07:36 -0600
parents a7c66ffbec7c
children
line wrap: on
line source

********************************************************************
* IDEDesc - IDE device descriptor
*
* $Id$
*
* IDE Defined Offsets
*
* Ed.    Comments                                       Who YY/MM/DD
* ------------------------------------------------------------------

         nam   IDEDesc        
         ttl   IDE device descriptor

* IT.STP (offset $14)
*  Bit Meaning
*  --- ---------------------------------------------------------------
* 
* IT.TYP (offset $15)
*  Bit Meaning
*  --- ---------------------------------------------------------------
*  7   Hard Disk:  1 = hard disk, 0 = floppy disk
*  6   Fudge LSN0: 0 = OS-9 disk, 1 = non-OS-9 disk
* 
* IT.DNS (offset $16)
*  Bit Meaning
*  --- ---------------------------------------------------------------
*  1   Force CHS:     1 = Use CHS, 0 = Use LBA if drive supports it
*  0   Master/Slave:  0 = master, 1 = slave
*

* Interface Address
ADDR     set   $FF50     

Master   set   %00000000
Slave    set   %00000001
ForceCHS set   %00000010

DriveSel set   Master


* Driver specific fields
ITDRV    set   $00       
ITSTP    set   $00       
ITTYP    set   $80       
ITDNS    set   ITDRV

ITSOFS1  set   $00       
ITSOFS2  set   $00       
ITSOFS3  set   $00       

* Default Geometry
Sides    set   $20       
Cyls     set   $100      
SectTrk  set   $0020     
SectTrk0 set   $0020     
Interlv  set   $01       
SASiz    set   $08       

        IFP1            
         use   defsfile  
        ENDC            

tylg     set   Devic+Objct
atrv     set   ReEnt+rev 
rev      set   $0        

         mod   eom,name,tylg,atrv,mgrnam,drvnam

         fcb   $FF        mode byte
         fcb   HW.Page    extended controller address
         fdb   ADDR       physical controller address
         fcb   initsize-*-1 initilization table size
         fcb   DT.RBF     device type:0=scf,1=rbf,2=pipe,3=scf
         fcb   ITDRV      drive number
         fcb   ITSTP      step rate
         fcb   ITTYP      drive device type
         fcb   ITDNS      media density
         fdb   Cyls       number of cylinders (tracks)
         fcb   Sides      number of sides
         fcb   $01        verify disk writes:0=on
         fdb   SectTrk    # of sectors per track
         fdb   SectTrk0   # of sectors per track (track 0)
         fcb   Interlv    sector interleave factor
         fcb   SASiz      minimum size of sector allocation
initsize equ   *         
*IDE Driver specific additions to the device descriptor go here
* NOTE: These do NOT get copied into the path descriptor; they
*       cannot due to the fact that there is simply NO ROOM in
*       the path descriptor to do so.  The driver must access
*       these values directly from the descriptor.
         fcb   0,0,0,0,0,0,0,0,0

        IFEQ  DD-true
name     fcs   /DD/      
        ELSE            
name     fcc   /H/       
         fcb   '0+ITDRV+$80
        ENDC            
mgrnam   fcs   /RBF/     
drvnam   fcs   /CCIDE/   

         emod            
eom      equ   *         
         end